Repair Procedures

Removal

1. Remove the wheel speed sensor bracket (A).




2. Remove the trailing arm mounting nut (B) from the rear axle assembly.
3. Remove the trailing arm mounting nut (C) from the body.
4. Remove the trailing arm (D).

Replacement

Trailing Arm Bushing
1. Using the special tools (09216-21600, 09552-38100), press-fit the bushing.




2. Remove the bushing from the trailing arm (A).
3. Using the special tool(09552-38000), replace the bushing.

Pull out force :over 100 kN (1000 kgf, 2204 lb)


NOTE:
Be sure to press the bushing with the jut of the bushing aligned to the longitude of the trailing arm.

Installation

1. Place the trailing arm (D) as shown below.




2. Install the trailing arm nuts.

NOTE:
Fully tighten the trailing arm mounting nuts with the vehicle on the ground in unloaded condition.

A. Install the trailing arm mounting nut (B).

Tightening torque :
140 - 160N.m (14 - 16kgf.m, 101.2 - 115.7lb-ft)


B. Install the trailing arm bracket mounting nut (C).

Tightening torque :
140 - 160N.m (14 - 16kgf.m, 101.2 - 115.7lb-ft)


3. Install the wheel speed sensor bracket (A).